Brightsign Object Reference Manual (FW 5.1) Instrukcja Użytkownika Pobierz pdf (Strona 216)

208

o open: An unobfuscated password for the DWS. This method uses digest access authentication. Specifying

this parameter without setting a port number will make the DWS accessible on the default port.

o basic: A flag indicating whether basic authentication should be used or not. Setting this parameter to True

allows the password set with the open parameter to be validated using basic authentication, rather than

digest access authentication. This option allows for backwards compatibility with older platforms; most, if not

all, modern browsers require basic authentication to be disabled in order to communicate with the DWS.

Note: The user name is "admin" for all authentication configurations.

• GetClientIdentifier() As String

• GetProxy() As String

• SetClientIdentifier(a As String) As Boolean

• SetLoginPassword(password As String): Specifies a login password for the SSH connection (if SSH has

been enabled in the registry).

• SetObfuscatedLoginPassword(password As String)

• SetObfuscatedWiFiPassphrase(password As String) As Boolean

• SetInboundShaperRate(rate As Integer) As Boolean: Sets the bandwidth limit for inbound traffic in bits

per second. For the default bandwidth limit, pass -1 to the method; for no bandwidth limit, pass 0 (though these

two settings are functionally the same). You will need to call Apply() for this setting to take effect, and changing

this setting at any time will cause the network interface to be taken down and reinitialized.

Note: Because of overhead on the shaping algorithm, attempting to limit the bandwidth at rates greater than

approximately 2Mbit/s will reduce speeds to less than the specified rate.

• SetRoutingMetric(a As Integer) As Boolean: Configures the metric for the default gateway on the

current network interface. Routes with lower metrics are preferred over routes with higher metrics. This function

returns True upon success.

• SetDHCP() as Boolean (interface): Enables DHCP and disables all other settings. This function returns True if

successful.

• SetIP4Address(ip As String) As Boolean (interface)

• SetIP4Netmask(netmask As String) As Boolean (interface)

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 340 341

Brightsign Object Reference Manual (FW 5.1) Instrukcja Użytkownika Strona 216